HPRE

Menu

Members Rides

checkerboard squares


in
Members Rides

Welcome, Guest. Please login or register.
Did you miss your activation email?
April 19, 2014, 12:08:53 PM

Login with username, password and session length

 

Author Topic: G5 trying fit bar end mirror handlebar  (Read 291 times)

bergerac

  • Neophyte
  • *
  • Posts: 15
  • Karma: 0
G5 trying fit bar end mirror handlebar
« on: January 04, 2013, 07:43:17 PM »
G5 attempting to fit bar-end mirror throttle side handlebar. Using correct size allen-key and hammer/long bar cannot shift it, that allen key is in there real tight. anyone else have problems ? Larry
2009 Black G5

mattsz

  • Grand Gearhead
  • *****
  • Posts: 1809
  • Karma: 0
  • moto-gurdyist
Re: G5 trying fit bar end mirror handlebar
« Reply #1 on: January 04, 2013, 07:52:38 PM »
Dunno if it helps, but my B5's bar-end weights were held very tight - there was a heavy application of some sort of thread-lock on the allen screws, which was hard to break, and even after I did, the screws backed out quite hard all the way.  I was a little concerned about stripping something, but the replacement screws went in just fine...

Ducati Scotty

  • Grand Gearhead
  • *****
  • Posts: 5608
  • Karma: 0
  • 2010 Teal C5
Re: G5 trying fit bar end mirror handlebar
« Reply #2 on: January 04, 2013, 09:15:44 PM »
They're held in with red Loc-Tite, it takes SERIOUS torque to get them out.  You can try tapping with a hammer or some heat from a torch or heat gun to soften it.  I just went with a ridiculously large wrench.

Scott

bergerac

  • Neophyte
  • *
  • Posts: 15
  • Karma: 0
Re: G5 trying fit bar end mirror handlebar
« Reply #3 on: January 05, 2013, 03:48:30 AM »
Dunno if it helps, but my B5's bar-end weights were held very tight - there was a heavy application of some sort of thread-lock on the allen screws, which was hard to break, and even after I did, the screws backed out quite hard all the way.  I was a little concerned about stripping something, but the replacement screws went in just fine...

Thanks Mattsz I'd better eat more spinach like popeye and try again!
2009 Black G5

bergerac

  • Neophyte
  • *
  • Posts: 15
  • Karma: 0
Re: G5 trying fit bar end mirror handlebar
« Reply #4 on: January 05, 2013, 03:49:50 AM »
They're held in with red Loc-Tite, it takes SERIOUS torque to get them out.  You can try tapping with a hammer or some heat from a torch or heat gun to soften it.  I just went with a ridiculously large wrench.

Scott
Thanks Scott, I'll try again
2009 Black G5