Ace - The current carb is Mikuni VM34mm. I just replaced the manifold from nfield. Will that one fit?
OK, got the carb in as well as the Goldie exhaust. First impressions -- it idles better (had a vm34 in before) and sounds great. It was a little hard to start though and on my little ride around the block it seemed to be lacking in power and struggled in high rpms. I had a hard time finding a good jetting start point on the board but went with a P6 needle, 30 pilot and a 190 main. Needle is in the original position. I'm at sea level and am using an ace canister. Engine is stock otherwise...Does this jetting sound OK for a start point? I'm willing to do plug chops just would like to have the correct jets around before I start. Any suggestions? Thanks.