Menu

Members Rides

Golden Gate Bridge


in
Members Rides

Welcome, Guest. Please login or register.
Did you miss your activation email?
April 16, 2014, 08:16:14 AM

Login with username, password and session length

 
 

engine cradle xs650 to royal enfield frame
Previous Image | Next Image
Description: Friend and I  thought a Subframe connector style engine girdle/cradle should be installed for added strength and ridgidity. After all the hp is being  tripled.
  Cradle attaches to frame in front @ downtube,  back  is bolted  to the old centerstand pin (ceter stand deleted).  Also to the motor in the front of the cylinder bases, in the middle at bottom of engine.  Lower stock tranny mounts removed. Motor offset to right side 3/4" via spacers to alin counter shaft sprocket. hole all the way though frontmost cross tube(welded) for highyway pegs if i want to add them later. RE side stand welded on between the rear frame bolt and RE foot peg crossbar. Minus the footpeg bar and spacer theres four pins total in this part. full Access to starter ,drain plugs and sump filter.
 
Picture Stats:
Views: 1502
Keywords: yamaha xs650 motor royal enfield 
Posted by: 500KsGerry January 24, 2010, 11:17:41 PM

Rating: ***** by 1 members.

Image Linking Codes
BB Code
BB Thumbnail Image Code
Direct Link
0 Members and 1 Guest are viewing this picture.

Comments
Ice
Hypercafienated
Grand Gearhead
*****

Karma: 0
Posts: 5009


Ride In Paradise Cabo, Don and Ernie


View Profile
January 30, 2010, 09:35:21 AM
Nice job. Looks like a factory part right out of the 60's or 70's
500KsGerry
Grand Gearhead
*****

Karma: 0
Posts: 539


Remember when decency wasn't a option?


View Profile
January 27, 2010, 11:42:53 PM
Found  that the steel between the kickstand and the rear frme boly hole will have to be beefed up =p
Other than  that  so far so good.



Powered by SMF Gallery Pro